AND USER MANUAL INST
When “ Use gen input as load output” is enabled, the “GEN” input turns into an output to power high-power loads such as a water heater, irrigation pump, AC unit, pool pump, or any other load.
At least 15 cm (6 in.) is required for smooth ventilation. cabinet. To avoid damaging the power supply element, install the baffle in the open space to help the air circulation inside the cabinet. Use the door with holes to install the system power supply inside the cabinet. upward. Install heavy equipment only at the bottom of the cabinet.
The document provides installation instructions for an APM30 cabinet in three parts: 1) Installing the base and extended battery cabinet, including using expansion bolts and fireproof clay. 2) Installing the APM30 cabinet and connecting the PMU, PSU, power cables, and grounding cables.
Use the door with holes to install the system power supply inside the cabinet. upward. Install heavy equipment only at the bottom of the cabinet. Install only one device or system power supply at a time. Remove the cabinet door or side cover temporarily to facilitate installation. The system power supply must be grounded.
Most UPS models can support up to four battery cabinets. A breaker switch is located inside each battery cabinet supplied by the UPS manufacturer. However, due to space limitations, your battery cabinets may not be located in the same area as your UPS.
.PDF includes complete article with source references.
Download UPS datasheets, battery sizing guides, and power redundancy white papers.
Via Monte Rosa, 91
20149 Milan, Italy
Italy (Sales): +39 06 8745 3292
Italy (Support): +39 335 729 8537
Mon-Fri: 9:00 AM – 6:00 PM (CET)