For other warranty options, visit The MultiConnect Conduit IP67 Base Station (MTCDTIP) is a LoRa IoT gateway device designed for outdoor deployments. An installation guide ships with the MCDTIP and is also available at and
Installation must comply with local and national electrical codes. When installing or replacing the unit, the ground connection must always be made first and disconnected last. Disconnect POE power (Ethernet POE port) before servicing IP67 Base Station. Do not work on the system or connect or disconnect cables during periods of lightning activity.
Disconnect POE power (Ethernet POE port) before servicing IP67 Base Station. Do not work on the system or connect or disconnect cables during periods of lightning activity. This device is not designed or approved to be used in any Hazardous Locations. Do not install or operate device if area is known to be an explosive environment.
4-66. This method has its advantages when mounting holes are parallel to the base or centerline of the equipment. Use this method using the following steps: 1. Measure from the center or base line and mark the location of the mounting hole center at each end of the lineup. 2. Snap a chalked line between the marks made in step 1. 3.
.PDF includes complete article with source references.
Download UPS datasheets, battery sizing guides, and power redundancy white papers.
Via Monte Rosa, 91
20149 Milan, Italy
Italy (Sales): +39 06 8745 3292
Italy (Support): +39 335 729 8537
Mon-Fri: 9:00 AM – 6:00 PM (CET)